m m m m m f t w l dimensions and ratings cap. < > < >< l _.050" > 1.625" min. _ .050" + + _ .050" w t < > electronic film capacitors, inc. reidville industrial park * 41 interstate lane * waterbury, connecticut 06705 phone (203) 755-5629 fax (203) 755-0659 oval wrap and fill + (all dimensions in inches) efc will manufacture to any non-standard value and size. please consult factory for special requirements. metallized polyester capacitors efc SP1313TF SP1313TF 1.0 1.5 2.2 3.3 4.7 lead gauge i rms amps i peak amps m m m m m f t w l cap. 1.0 1.5 2.2 3.3 4.7 lead gauge i rms amps i peak amps .360 .450 .500 .550 .620 .560 .650 .800 .840 1.010 1.125 1.125 1.125 1.250 1.250 20 awg 20 awg 20 awg 20 awg 18 awg 2.0 2.0 3.0 4.0 4.0 7.0 11.0 16.0 19.0 26.0 41 m w 34 m w 28 m w 23 m w 19 m w .550 .690 .630 .790 .960 41 m w 34 m w 28 m w 23 m w 19 m w 10.0 14.0 16.0 23.0 33.0 2.0 3.0 4.0 4.0 4.0 20 awg 18 awg 18 awg 18 awg 18 awg .850 .990 1.020 1.180 1.360 1.200 1.200 1.560 1.560 1.560 SP1313TF-3 250 vdc SP1313TF-3 400 vdc insulation resistance (min.) +25 o c +85 o c megohms x microfarads 30,000 3,000 need not exceed (megohms) 50,000 3,000 100 khz esr (max.) efc series SP1313TF capacitors are designed specifically for switching power supply applications, where current and low e.s.r. values are important. capacitance drift over time, due to humidity, temperature cycling or operation life are negligible. electrical characteristics, such as insulation resistance (i.r.), dissi- pation factor and dielectric absorption are superior in this metallized polyester capacitor as compared to the characteristics displayed by electrolytic capacitors. in switching power supply applications requiring medium current, the size and weight savings of the series SP1313TF capacitors coupled with the superior electrical characteristics mentioned above make SP1313TF capacitors the ideal choice in your new or existing switching power supply. case is flame retardant - tape wrap construction with epoxy end seals. capacitance tolerance: standard is +/- 20%. also available is +/- 10% and +/- 5%. the tolerance applies when measured at 1000 +/- 20 hz at 25 o c. temperature range: -55 o c to +100 o c. humidity resistance: tested as outlined in mil-std-202c, method 103b, condition a. after final condition ir, no less than 1/2 minimum values listed in table above. dielectric strength to withstand test as outlined in par. 3.4. one failure allowed of 18 units tested. notes: 100 khz esr (max.) http://www..net/ datasheet pdf - http://www..net/
|
